Flowed racing crankshafts are the hottest new crankshaft upgrade in the racing world. There´s been a lot of experimentation that has resulted in the innovations we see here establishing themselves. In our SERIE PRO line, we have upgraded crankshafts from the German tuning master WORB5, based on MAZZUCHELLI (PX) and TAMENI (T5) shafts.
The crankwebs have been specially modified and gas flowed. The German word ‘gelippt’ (=flowed) has established itself as the description of this new hit. The shaft contour is designed to guide the fuel mix through the crank flange instead of hitting it on entrance. This keeps your fuel flow moving steadily instead of being blocked or creating unnecessary turbulence. Flange modification allows more usable volume. Compression sinks, more fresh fuel can flow in and a higher fill is achieved. This interaction allows higher speed ranges and pumps up performance. Additionally, the crankshafts are finely balanced; the connecting rod swings at 12 o`clock. Give your T5 a real treat when you outfit it with this racing shaft.
Conclusion: higher performance than regular racing crankshafts with less vibration.
Flowed racing crankshaft / stroke 42-57 mm / connecting rod 105-110 / 24/25 mm, M12
Flowed racing crankshaft, with ø 95 mm crankweb (flywheel side), ø 97.9 mm crankweb (disc valve side), balanced at 12 o'clock, lower connecting rod bearing = silver bearing, 105 mm connecting rod (125/150 cc) or 110 mm connecting rod (200 cc), 42 mm stroke (T5) or 57 mm stroke (PX), oil seal housing 24 mm, bearing housing 24 mm, stump cone with M12 thread, incl. connecting rod bearing.
SIP-TIP: new bearings, shaft gasket rings and woodruff key are a must, a SI 24-26 or PHB 28-30 carburettor kit, a touring exhaust and a SIP PERFORMANCE by VAPE/PARMAKIT ignition are worthwhile additions.
The timings stated above were determined viewing in the direction of the clutch side. That means: "138°/6° after TDC: Inlet timing begins 6° after TDC and stays open for 138°.
Please note that the angular degrees given here are approximate values, as the crankshafts are reworked by hand.
