Name: Piston EGIG Performance 170 cc
Brand: EGIG Performance
SKU: 75413300
Price: 109 EUR
Availability: InStock

Product image Nr. 0 for 'Piston EGIG Performance 170 cc'

Product image Nr. 1 for 'Piston EGIG Performance 170 cc'

Product image Nr. 2 for 'Piston EGIG Performance 170 cc'

Product image Nr. 3 for 'Piston EGIG Performance 170 cc'

for Vespa 50-125/PV/ET3/PK/S/XL/2

Show all matching vehicle models

Material: cast iron
Ø 65mm
2 piston ring(s)
Pin 15mm

TUNING SPORT - powerful

For race use only. Not admitted in the area of the German StVZO!

Free shipping

€109.00

VAT included

220g / Piece

Product description

Large-volume cylinder from EGIG Performance in gray cast iron for the Vespa smallframe models.

EGIG Performance takes an unusual approach with the 170 cc tuning cylinder. All that is needed to accommodate the 170 cc on a Smallframe Engine is a special Shaft with a 115 mm Conrod.

170 cc
Easy to install
High torque

The kit is designed to be high-torque, suitable for everyday use and affordable - and almost "plug and play".

99 % - plug and play

This means that everything can be installed without any milling work, completely without any special tools. The dust protection lip of the fan wheel housing on the cylinder sealing surface must be sawn off to a height of 2 mm. The SIP Evo engine block is 100% P&P, provided that the Crankshaft with a connecting rod length of 115 mm has been installed. Thanks to the one-piece exhaust and its overflow layout in conjunction with a relatively large displacement for an SF, the Cylinder is a real torque beast. Even with an original gearbox (without short 4th gear) and 2.46 primary, accelerating through 35-135+ km/h without a power gap is no problem. This was tested in conjunction with the EGIG Superbanana Sport.

Technical details

170 cc
51 mm stroke
115 mm Conrod
65 mm bore
6 transfer ports
One-piece exhaust with 66
Timing 124°-184°
Gray cast iron
2 Piston Rings
Direct suction
Engine block-suctioned Reed Valve or Disc Valve
No milling work necessary on the Casing
Intake Manifold stud spacing 54.5 mm
Stud spacing at exhaust 56 mm
Outputs of over 25 hp and 24 NM are possible without milling work
Recommended mixing oil: 1:33 with Motul 800

Scope of delivery

Cylinder EGIG 170
Cylinder Head EGIG 170
Piston with Replacement Parts d65
Intake Manifold Gasket
M7 cap nuts and washers
Screws, Cylinder Head and Exhaust

The best setup - our SIP-TIP:

The Egig 170 can only be fittedin conjunction with the corresponding Crankshaft.
The Egig Superbanana is the perfect addition for a beautiful everyday setup.
With the "One Finger Clutch" from Egig, power can be transmitted comfortably.