Gear Selector Rod P/A for
Vespa 125 GT 2°/GTR 2°/TS/150
Sprint 2°/V 2°/Super 2°/180
-200 Rally 2°/P80-150X/P150S
1°/P200E/PX80-200 E/Lusso 1°
The gear selector rod connects the gear selector box on the outside of the motor, with the gear cog selector cruciform inside the motor. This enables the cruciform to be placed exactly in position within the desired gear cog on the output shaft every time you change gear and make sure that the power of the motor can be effectively transmitted through the desired gear, to the output shaft, and finally the rear wheel. Always make sure you order the gear selector rod specific to your type of engine. Otherwise the gears will not remain selected and will jump out during use.
Helpful Hint: Do not forget to secure the cruciform properly on the selector rod during assembly and to remember the left handed thread of this particular item.
SIP-TIP: Always check that you assemble the gear cogs correctly arranged and in the right order . Do not forget to measure the end float to be sure of the correct tolerances for your output shaft assembly. Check the cruciform and selector box for wear and always use fresh gear box oil!
OEM Numbers (for the purpose of comparison)