Pictures may look different
Gear Cog 52 teeth, 2nd gear,
for Vespa 125 Super 2°/150
Super/GT (CH)/(F) 1°/P150S
1°, VBX1T -> 169035,
Ø 106,5mm, mid section: 4,9mm
The arrangement of gear cogs on the output shaft combined with the smaller cogs of the primary drive assembly form together the final drive ratio of your motors gearbox setup. If this is not, quite literally, geared to the needs of the other components included in the motor, even the strongest cylinder will not help. You can either be constantly revving the life out of your motor or not have enough momentum available to change up to the gears. A cleverly chosen final drive ratio, often achieved by the replacement of just one gear cog, can work wonders to your acceleration and gear changing process.
Gear cogs, as with any other mechanical component, are exposed to wear and tear. Motors with higher mileage or performance show obvious signs of mechanical erosion, especially in the grooves where the gear selector cruciform sits during use. If they are rounded of or otherwise damaged they will need replacement.
SIP-TIP: Do not forget to replace the relevant spacers, safety washers, oil seal, cruciform and shaft bearing.
OEM Numbers (for the purpose of comparison)
152801 - 110508 (PIAGGIO)
Customers also searched for this article with:
gearcog, Gear wheel
This article can be found in the following exploded drawings ...
Go to Exploded Drawings!
for this item
might interest you...