Long stroke, flowed crank shafts are the newest update for long stroke shafts. In our SERIE PRO line, we have modified shafts from the workshops of German tuning master WORB5, based on MAZZUCCHELLI and MEC EUR crankshafts.
The crankwebs have been specially modified and streamlined. The word "gelippt" (=flowed) has established itself as the description of this new hit. Shaft contour design guides the fuel mix through the crank flange instead of hitting it face on when entering. This will keep your fuel flow moving steadily instead of getting blocked or creating unnecessary turbulence. Flange modification allows more usable volume, crankcase compression sinks, more fresh fuel flows in resulting in higher fill. This interaction results in higher speed ranges and increases performance Additionally, shafts are finely balanced, the connecting rod swings at 12 o'clock.
The form of the EVO crankshaft is more extremely flowed and, additionally, laser welded. This is as good as it gets with a disc slide valve. And to top it off, they're super durable and run really quiet. We recommend this version for motors intended for 25 hp and more. All 62mm crankshafts are outfitted with a DRT excenter stud and 62 mm stroke. Your cylinder will need raising and the crankcase will need modification.
Conclusion: higher performance than normal long stroke crankcases, and less vibrations.
Long stroke flowed crankshaft/ stroke 60/62mm / connecting rod 105-110mm / 24/25 mm, M12
Long stroke flowed crankshaft, with ø 95mm crankweb (flywheel side), ø 97.9 mm crankweb (disc valve side), balanced at 12 o'clock, lower connecting rod bearing = silver bearing, 105 mm connecting rod (125/150 cc) or 110 mm connecting rod (200 cc), 60/62 mm stroke, oil seal housing 24 mm, bearing housing 25 mm, stump cone with M12 thread, incl. connecting rod bearing.
SIP-TIP: SIP/MMW long stroke cylinder head, MALOSSI 210cc and SIP Road exhaust for touring set up, 1.5 mm base gasket, SIP Performance/RZ/DSE exhaust, MALOSSI or POLINI, 28-30 mm carburetor as basic for sport set up. Try out a variety of head/base gasket thicknesses.
Helpful Hint: We recommend the exclusive use of TORRINGTON flywheel big end bearings (90021000) with these crankshafts. The use of a LOCTITE thread locking gel (Art.Nr.14101000) is also needed when used in combination with performance orientated motor setups.
The above mentioned inlet port timings are measured while looking at the crankshaft with the clutch shaft facing away from the person measuring it. For example '138°/6° after Top Dead Centre' (TDC) means the inlet opens at 6° after TDC and remains open for another 138°.
Please consider that the given inlet port timings are not always 100% accurate, due to the fact that these crankshafts being modified by hand!
Customers also searched for this article with: long stroke flowed crankcase