Hola a todos les escribo desde la ciudad de Castellon (España).

Resulta que hace un tiempo adquiri un rodamiento de agujas para el embrague de mi vespa Iris, aqui pongo una foto:

http://img831.imageshack.us/img831/3255/p101221080151.jpg

Esta instalado en el embrague de mi vespa desde hace un tiempo y no hay problema alguno, no es que note nada extraño en el embrague pero quizas cambia mejor de marchas.

Hello everyone I am writing from the city of Castellon (Spain).

It acquired a while ago a needle bearing for the clutch of my scooter Iris, I put a picture here:

http://img831.imageshack.us/img831/3255/p101221080151.jpg

This clutch installed on my scooter for a while and no problem, not you notice anything strange in the clutch but maybe better gear changes.

Un saludo a todos - greiting

I had no camera on hand, but tried mounting the bearing on a very worn out 6-spring GL150 clutch. 

It went on with out problems and spins around quite nicely. Hopefully there will be no more lurching. 

The fact that it fit on an old worn out clutch, but not a newer one might indicate this part is only good for use on older worn out clutches where no bushing will fit tightly.. 

m.

Thanks for your reply.

The px200 7-spring clutch I tried it on now has a new brass bushing instead. I am however going to give this a try on my older GL with the smaller clutch. 

I'll see if I can make a video to demonstrate the problem..

Never heard about that problem! I will get in touch with you soon!